Bully Dog
Bully Dog Triple Dog GT

Bully Dog Triple Dog GT
Triple Dog Special Edition Jeep JK Gas Gauge Tuner 2007-2013 Jeep JK

TUNING OPTIONS:
REG /TOW: 11.5 HP, 15.3 TQ, ENGINE FAN TURNS ON HIGH SPEED AT 205° F COOLANT TEMP LEVEL. This tune is great for everyday driving and towing use. This tune is meant for use with regular octane pump gas but any OEM approved fuel will work.
PREM/SPEED: 15+ HP, 20+ TQ, ENGINE FAN TURNS ON HIGH SPEED AT 205° F COOLANT TEMP LEVEL. This tune is meant to maximize your potential horsepower. A minimum of 91 octane gasoline is required to avoid risk of engine damage.
OFF ROAD: 11.5 HP, 15.3 TQ, ENGINE FAN TURNS ON HIGH SPEED AT 200° F COOLANT TEMP LEVEL. The off road tune is very similar to the Reg/ Tow Tune power wise. However, to make the tune more effective off road the throttle sensitivity has been retuned for more control. Our throttle mapping is less sensitive than OEM tuning at lower throttle % engagement to give off-roaders more control over the actual power that they put to the ground.

SPECIAL FEATURES:
We have packaged some excellent features into the GT Gas that really increase the utility of the Jeep JK beyond what the OEM will let you do. These features can be accessed from the specials functions menu. See below for a list of special features.

.


Free Shipping
Bully Dog - Triple Dog GT 2007-2013 Jeep JK (California Approved)
HP/Torque Increase
Quantity
Order
#40410: Triple Dog GT for Gasoline Vehicles $499.99
15+ hp/20+ lbs.ft.
Bully Dog - Triple Dog GT 2007-2013 Jeep JK (Not for sale in CA)
HP/Torque Increase
Quantity
Order
#40440: Triple Dog GT for Gasoline Vehicles $499.99
15+ hp/20+ lbs.ft.

Special Features :


ENGINE FAN :
Stock Setting: The engine fan will activate its low speed setting if coolant temp reaches 215° F and its high speed setting will activate at about 225° F. Press disable to return to stock setting.
GT Gas Setting: Enable the Engine Fan feature to run the engine fan in high speed mode at any coolant temperature level. Since it works like an On/Off switch the engine fan will remain on until it is changed back to disable. (This feature does not take effect until the GT is at the Main Gauge Screen.)

IDLE UP:
Stock Setting: 700 RPM. Press disable to return to stock setting.
GT Gas Setting: 500-1500 RPM. Enable and select a value for the Engine Idle
position. This is a great feature for keeping voltage in the vehicle up while
running auxiliary electronics off of the vehicles power system. Running a winch
would be a prime example of when this special feature comes into handy.
(This feature does not take effect until the GT is at the Main Gauge Screen.)
This feature only works in park or neutral and will automatically turn off as
soon as the vehicle is put into gear. It will automatically turn back on the next
time a vehicle goes into an idle position.

TIRE PRESSURE MONITORING SYSTEM ADJUSTMENT:
Stock Setting: A stock Jeep will have preset value in the ECM of 30-34 PSI
depending on the vehicle. The OEM TPMS system will allow for a variation in
tire pressure from the stock set level + or - 6 PSI before it throws a light. Press
disable to return to stock settings.
GT Gas Setting: change the stock preset value to an number from 10-60 PSI.
Once that setting is changed the OEM TPMS system will still allow for the + or - 6
PSI variation so tire pressure could be reduced to as low as 4 PSI. FYI: the sensors in
the tires and value on a manual pressure tester will not necessarily match.
DISABLE TRACTION CONTROL (COMPLETELY):
Stock Setting: Enabled. Press enable to return stock setting.
GT Gas Setting: Disabled: Highlight the “disable” button to instantly turn
off traction control. (Upon re-enabling traction control to revert.

Special Features for Rubicons only (off road):
Further enhance the utility of the Rubicon edition with these additional special features.

SWA Y BAR DISCONNECT:
Stock Setting: Disable for 4WD Low only up to 18 mph. Press disable to return
to stock setting.
GT Gas Setting: 4WD Low, 4WD Hi, and 2WD up to 30 mph. To enable highlight
the enable button and return to main screen, then press the sway bar button
on the vehicle dash. At 30 mph and above the sway bar will automatically
reconnect itself as a built in safety feature. If a vehicle returns to a level below
30 mph the sway bar will automatically disconnect as long as on dash button
is still activated.
LO CKERS (FRONT AND REAR DIFFERENTIALS):
Stock Setting: Lock front and rear diffs in 4WD Low only. Press disable to
return stock setting.
GT Gas Setting: Lock front and rear diffs in 4WD Low, 4WD Hi, and 2WD. To
enable highlight the enable button and return to main screen, then press
the locker button on the dash once for rear and twice for front and rear. Front
locker will automatically unlock above 20 mph, Rear locker will automatically
unlock above 30 mph. Both lockers will automatically reengage (lock) if
vehicle returns to acceptable speeds and the system is still activated.

OTHER SPECIAL FEAT URES NOT RELATED TO OFF ROADING (ALL JEEPS):
Below is a list of features that you will find in your special features menu, but really have nothing to do with off roading. These are all
about personalizing.

Accessory Delay:
Set the amount of time that the accessory items in the vehicle will remain
on after the engine has been turned off and the doors remain closed.
Accessory items include the radio, cigarette lighter, etc. Choose between
0 seconds, 45 seconds, 5 minutes, 10 minutes, 30 minutes, or 60 minutes.
If doors are opened then all accessory items will automatically turn off as
they do stock.
Head Lamp Delay:
Set the amount of time that the head lamps remain on after the engine
has been turned off. Choose between 0 seconds and 80 seconds in 5 second
increments.
Horn Chirp on Lock:
Enable this feature to hear a horn chirp each time the doors are locked
while using a remote door lock system.

Optical Chirp on Lock:
Enable to see a flash of the hazard lights each time the doors are locked
while using a remote door lock system.
Auto Door Lock:
Enable to lock all doors in the vehicle any time the vehicle reaches speed of
15 mph. Once the vehicle comes to a complete stop, if the driver’s door is
the first to open then all doors will automatically unlock.
Unlock Driver Door:
Enable to unlock driver door with one press of the button on a remote door
lock unit, the second press of the button will unlock the rest of the doors.
Disable this feature to unlock all of the doors with one press of the button
on a remote door lock unit.